Chain link fence installation manual before you begin.
Chain link fence instructions.
This will help avoid encroaching on adjoining property with concrete footings.
If you plan on installing privacy slats or another type of material that will increase wind load consider using 8 or 6 post spacing.
Check all the regulations about fence setbacks type and height.
11 steps of chain link fence installation step 1.
Chain link fence posts are typically spaced a maximum of ten feet apart.
Follow the fence manufacturer s instructions for spacing which typically ranges from 4 10 apart spacing should not exceed 10 on center.
Most fence installers recommend that all posts be set approximately 4 inside the property line.
The key point to remember with chain link fencing is that in order to achieve a rigid strong fence your posts must be concreted in line wire needs to be tensioned along the fence line and the chain link must be tensioned and secured correctly to the posts and line wire.
As chain link fence posts are smaller and sturdier than many other types the holes should be smaller and can be farther apart.
Step 2 with crayon or chalk mark the ground line on posts.
Once you have determined the property line and legal setback mark out the location of the fence.
Locate your property s line.
Leave the concrete a few inches below ground level.
There may be local zoning or deed restrictions pertaining to height and type of fence.
Mark the fence location.
Slope it away from the post to help with water runoff.
If using fast set concrete pour the dry mix around each post to a few inches below ground level and add water.
The exact diameter and depth will be determined by local weather and soil conditions.
Check out your property line setback requirements.
For aesthetic reasons space posts evenly but do not exceed ten feet between posts.
Find surveyors pins if the fence is to be located near property lines or have the lot surveyed.
Use a rubber mallet to drive end post caps onto the gate corner and end.
1 the good thing is that you can dig all the post holes at once.
Initially the water will sit on top but eventually will work its way to the bottom.
Mark the fence location before you start have the local utility company mark all underground utility lines.
Put hinges and latch hardware onto the gate posts at roughly their final positions to install later.
Also be sure to determine the property boundary and the local setback rules.
Chain link fence gate installation instructions figure 2 figure 3 figure 4 step 1 dig terminal post holes approximately 8 in diameter and 30 deep with sloping sides fig.
The bands will help hold the mesh in place once it s installed.
Obtain necessary zoning and building permits.
