Set the vanity in place.
Changing bathroom vanity top.
Start by cutting off water and disconnecting and removing old fixtures.
How to remove and replace a bathroom vanity top step 1.
Studfinder tape measure level pencil drill with screwdriver bits jigsaw as needed coping saw as needed small profile gauge as needed caulk gun.
Buy your new vanity top according to these measurements.
Figure out the center every bathroom sink or vanity top has three holes cut at.
Disconnect the drain pipes from the existing sink unit using a pipe.
A custom vanity top maker based in georgia will design vanity tops as long as 140 inches and as deep as 30 inches.
If the old vanity is marble or granite it will not be screwed on.
Remove screws underneath cabinet.
Measure the vanity base with a tape measure and write down the measurements.
Mark the placement of the new vanity s screw holes.
Find the studs and position the vanity locate the wall studs and mark them a little higher than the top of the new vanity.
Cut caulk between backsplash and vanity with utility knife.
Remove the doors from the vanity cabinet using a screwdriver to make it easier to work.