Changing Bathroom Vanity

To get the perfect 90 degree angle on their new vanity countertop homeowners carved out a bit of drywall at the corner of the vanity top then sealed the deal with a thin bead of silicone.

Changing bathroom vanity.

Turn off the water and disconnect the supply lines. Cut caulk between backsplash and vanity with utility knife. Loosen the caulk between the vanity and the wall with a utility knife. Use a bucket to catch any water that drips from the supply.

On the sides go all the way down to the. Studfinder tape measure level pencil drill with screwdriver bits jigsaw as needed coping saw as needed small profile gauge as needed caulk gun. Start by cutting off water and disconnecting and removing old fixtures. If the old vanity is marble or granite it will not be screwed on.

The standard vanity base has been removed and replaced with classic tulip furniture legs to give the appearance of a stand alone piece of furniture to this diy vanity. In this distressed bathroom vanity transformation dated oak gets a face lift with bold turquoise chalk paint that has been antiqued and waxed. Disconnect the sink trap from the sink s tailpiece vertical drainpipe by hand. Remove screws underneath cabinet.

Apply silicone caulk to the top of the cabinet. A cool coat of gray paint new cabinet hardware and a fresh faucet complete the vanity makeover. Shut the hot and cold water shut off valves underneath the sink. Set the vanity top into position and firmly press down.

Make sure the wall is straight and there are no gaps between the wall and vanity. How to replace a bathroom vanity 1. Use an adjustable wrench to disconnect the hot and cold water supply lines from the shut off valves. How to replace a bathroom vanity step 1.